0 Members and 1 Guest are viewing this topic.
I was having issues with the braided line on my spinner reels. I wasn't able to get it to grip onto the reel for most of the morning. Once the line got wet and was wound a few times it got better, but was never perfect. Is there something I need to do different when spooling it? I don't have this issue on my deep sea reels, so I know it's not "that's just how braided line works".
Open face for most everything ,for Jigging and slip bobbering I use Pflueger Presidents 20,s and 25,s for 49.99 and 59.99 you can not buy a better reel, spend more if you like but these will outlast most everything else ( I have several Shimanos seldom use them ) and balance really well on a 5'6" to 7.5 ft rod ,all of them are spooled with Fireline crystal on some as light as 2lb test most have 4 lb . For casting really light jigs I use the large spool Pfleugers in the 30 size and again fireline 2 lb test (I have seldom had a break off from fighting a fish with fireline that includes up to 45 inch Northern pike the drag is that good on a President ). My theory on Rods particularly jigging rods is simple find an one piece action you like for the weight of bait you are going to use then give it this simple sensitivity test , hold the rod In your casting hand place your thumb on the blank gently touch the rod tip to the carpet or floor go over some imperfection in the surface you are touching if you can not feel it you with you thumb put the rod back in the rack. You will be surprised how many $50 rods pass this test and how many $200 ones do not . Seriously trolling , cranks , spinners bottom bouncers for Walleye , small mouth , musky etc I use Garcia C3 except when a line counter is required then I use Daiwa 17 ,27 ( for lead core a 47) all with 10 -14 lb fireline .I have to agree with Art on the long poles,any open face with 4 bearings or more I can buy for $20. cause on a long pole 10-16ft , it don't matter, you do not reel in unless you are long lining then not nearly as much as when you are casting or jiggin so get a good B&M pole or Poles and save a bit on the reels . I really do not know anyone who uses closed face equipment up North as they do not have the durability to stand up against really big fish. I do have a few 33s for the grandkids to start off with . Now that I actually think about it maybe I have way to much fishing equipment .... Naaaa ! got the attached on a Penn open face in Costa Rico. Bottom line is use what works for you .
You need to start initially with mono (maybe fluro) several turns and then tie your braid or crystal fireline. They call it the backing I believe. This has you put a lot more backing on. That'll prevent it spinning.http://www.onthewater.com/how-to-spool-a-spinning-reel-with-braided-line
I have used a lot of different brands and found many I like. Pinnacle, Quantum energy, Diawa Legalis, Okuma Ceymar, Shimanos (Slade, Sedona, Sahara, Symetre, and several bass pro brands. Only ones I consistently had trouble with were the bass pro reels, that being said they were not the higher end models. Screws would back out during operation and usually fall in the water, bearings got flat spots or bound up and froze, anti reverse broke on one. I may just be unlucky and haven't purchased one in several years so quality could have improved too. If your not on a budget the symetre and enegry are pretty nice smaller spinning reels. Best reel on a budget at this time I would recommend the Okuma Ceymar, think they are about $40 at sportsmans and I use mine for casting for crappie and also as my drop shot reel for bass. Haven't had any issues with it. My long rods are strung with 8 or 10 lb power pro which I tie to a swivel. All my jig double jig set ups and drop shot rigs are pretied to clip on as needed which I learned from Sparkchaser. Braid lasts for a long time and you don't get the line memory if you don't use it often like me. Like Matt said though if you are having trouble with braid not gripping the spool, use some mono or flouro backing and fuse the line with a surgeons knot.
The BPS Johnny Morris bait casters are not all that quality either for the price you pay?